FTTH Termination Box MCO-P2

FTTH distribution box MCO-P2 is intended for use as a low-capacity optical distribution box, for mounting optical cables, laid (suspended) in the open air and inside technical premises (attics, basements).

It is made of plastic and has a dust-splash-proof dead-end design (optical cable input and output of drop cables are made on one side).

It is a small-sized rectangular box with a hinged lid. The cover is attached to the housing with a plastic loop.

Fixation and sealing of the lid is caried out with four plastic latches on steel spring hinges.

Along the perimeter of the box, at the points of contact with the cover, there is an elastic gel, which seals the body and seals the input cables.

In the lower part of the case there is a removable block for input and sealing distribution fiber-optic cables on one side and drop cables on the other side of the block. The removable block has a gel coating over the entire surface of contact with the cable and the box body.

A removable mounting panel (insert) is installed inside the box, on the back side of panel is space for accommodating transit cable loop, clampsand cassete for fiber splices are instelled. On the front side of the panel there are sockets for installing SC (LC suplex)  adapters. Steel tube type PLC splitters with 1 meter long fibers can be installed. Installation of one PLC splitter 1*8 or two PLC splitters 1*4.  The space for splitters and cable splices is protected by a special plastic cover.

The design of distribution box FTTH distribution box MCO-P2, despite the small overall dimensions, provides the possibility of organizing a transit loop of optical cables without their cutting.

The design of the distribution box provides:

• insertion and fastening of two cables with diameter up to 16 mm;

• the possibility of organizing a transit input of one optical cable;

• placement of up to 36 splices of optical fibers (protective sleeves) and 12 splices of drop cables;

• installation of two optical PLC splitters with a housing size of 60x7x4 mm;

• installation of up to 12 SC adapters (LC duplex);

• dust-proof round output for up to 12 drop-cables with diameter up to 5 mm or flat drop cable.

Installation of the box on walls and pillars is carried out using bracket kit